Not sure if any of you ventured into the "Fiberglass" section on OSO - but over the past 3 winters I turned my
F-16 2 person canopied race boat into.....
[ATTACH=CONFIG]522761[/ATTACH]

A 4 Person canopied race/poker run boat.. and now its time to wrap it.
[ATTACH=CONFIG]522762[/ATTACH][ATTACH=CONFIG]522763[/ATTACH]

#1 Ideas im looking at - ALL Matte Red with metal flake
[ATTACH=CONFIG]522764[/ATTACH]

#2 All Matte Black with metal flake
[ATTACH=CONFIG]522765[/ATTACH]

#3 All Matte Black _ (just murder it out)
[ATTACH=CONFIG]522766[/ATTACH]

#4 All Chrome red wrap
[ATTACH=CONFIG]522767[/ATTACH]

#5 or cheetah PRINT THE WHOLE DAMM BOAT...
[ATTACH=CONFIG]522768[/ATTACH]

The rear engine room hatches, front bow hatch and 2 canopy hatches would be wrapped in matte carbon fiber on each design..

red chrome looks awesome

Sorry, but I don't like any of the above. I think the chrome will be all water spots and the others will be to hot. I would keep the white and just add some graphics to it. Then the interior could be done in white with the same colors. Good luck, all that matters is that you like it.

Silver/Grey carbon fiber.....

I thought about that, than run Black / Red / Silver graphic over it.

Red/Black/Silver or Red/Black/White

Flat black with the chrome red would be a cool color combo. Not sure either of those will hold up well to the marine environment..... Cheetah print the dash and seat covers.

Killer Bunny . . . . . the most foul, cruel and bad tempered rodent you ever set eyes on . . . . https://www.youtube.com/watch?v=XcxKIJTb3Hg

Yes - or Dave's Pink/Gray Bunny design..

I like the red chrome.... But you better like spray detailer! That stuff's gonna require some upkeep!