Have two Lantham steering cylinders 16"closed 24"open.Shafts in great condition,chrome is not so hot on the cylinders not ate away but peeling there chrome over brass.Clevis ends 5/8"Could paint.Work fine no seal leaks.750.00 or offer plus freight.Located in Maryland



[ATTACH=CONFIG]533298[/ATTACH][ATTACH=CONFIG]533298[/ATTACH]

I have Latham tie bars (3) 2 sets of saddles couple Latham wing plates ,one is center plate with tie bars for triples.one bravo center cap for single ,would go nicely with those Latham rams if someone wants to build a budget system for the holidays

What you want for two wing plates maybe I'll put a set together and then try to sell

air junkey any decent squirt boats down that way with no power for sale.Son is looking south wind ,young blood,nordic,eliminater

I sent another guy here a line on a nice white kona set up for BBC power and I know where a gullwing with a vette 427 is that would be just about free after pull and sell 427 been sitting for years .I want it bad but have 4 boats now and a dozen engines .been a year since a eliminator pickle no power traded around here .red dominator pump it brought 4000 quick

2007 WarHawk TX 19 runs low 90's on motor 100 on the gas. Have not thought about selling it but you never know....email me if you are intrested I'll send pic's [email protected]

if your lookin for a jet boat I have 1 less power new Berkley pump and hyd place diverter
I also have a v drive I will sell less power 21 ft elim pickle fork

I have to dig out the plates and stuff I have ,been slammed haven't forgot about ya

ttt