33 Outlaw gauge bezel size....
02-16-2015 | 08:53 AM
#1
Thread Starter
Registered
Joined: Feb 2004
Posts: 3,710
Likes: 2
From: MT. JULIET, TN.
33 Outlaw gauge bezel size....
I know the small ones are 2 1/16 and I measured my speedo at 4-7/8 and tachs at 4-1/2. I dont see any bezels on CPperformance the size of my speedo and tachs. Did I measure them wrong?? I'm painting my panels silver and laying white carbon fiber hydro decal over them. Was going to add polished bezels for contrast...Is there a cheaper place to get these things?? $200 is butt hurt money for them 
02-16-2015 | 12:16 PM
#3
Registered
Joined: Dec 2002
Posts: 1,022
Likes: 12
From: Greenville, SC
I know the small ones are 2 1/16 and I measured my speedo at 4-7/8 and tachs at 4-1/2. I dont see any bezels on CPperformance the size of my speedo and tachs. Did I measure them wrong?? I'm painting my panels silver and laying white carbon fiber hydro decal over them. Was going to add polished bezels for contrast...Is there a cheaper place to get these things?? $200 is butt hurt money for them
02-16-2015 | 12:40 PM
#4
Thread Starter
Registered
Joined: Feb 2004
Posts: 3,710
Likes: 2
From: MT. JULIET, TN.
The standard monster gauges take the 4 5/8" bezel. The problem you will have is the older Gaffrig speedo were larger than the tachs. I'm not sure if you will ever find one with a 5" hole. You could always replace your speedo with a new monster GPS speedo and get a bezel for it.
So the 4-5/8 is what i need for the tachs.... That speedo may not get one!
