Teague Custom Marine 1050 in 27' Eliminator Speedster. Phoenix Arizona area.
02-05-2016 | 08:07 PM
#1
Thread Starter
Registered
Joined: Dec 2013
Posts: 54
Likes: 9
From: Phoenix, AZ
Teague Custom Marine 1050 in 27' Eliminator Speedster. Phoenix Arizona area.
02-08-2016 | 09:48 AM
#10
Thread Starter
Registered
Joined: Dec 2013
Posts: 54
Likes: 9
From: Phoenix, AZ
HI SkiDoc, I am using a IMCO SCX-3 with a IMCO SC Lower. On this recorded test pass I was using 1:36 gears with a stock 36P prop. My prop shaft height is about 1/2" above the outside sponsons, if I measured it correctly.
Octane Marine is setting up my other, or my spare -3SC lower with 1:28 gears for testing. I hit 125mph to 128mph on my 1st pass, I did not get it recorded on my sony camera, but I took a pic of the speedometer. Sorry about the sidways photo.
[ATTACH=CONFIG]550759[/ATTACH]
Octane Marine is setting up my other, or my spare -3SC lower with 1:28 gears for testing. I hit 125mph to 128mph on my 1st pass, I did not get it recorded on my sony camera, but I took a pic of the speedometer. Sorry about the sidways photo.
[ATTACH=CONFIG]550759[/ATTACH]
Last edited by EL Guapo; 02-08-2016 at 09:55 AM.
