Helping a buddy sell off some parts collecting dust. Although dirty and dusty in the pictures, all parts will be shipped clean. All prices are OBO. Buyer to pay shipping. Located in Alameda, CA. PayPal accepted. Feel free to PM me and I will reply as best as I can.

Unknown BBC Headers (Maybe Lightning?)
21" overall height
18.5" overall length
3.5" exhaust outlet
2" round exhaust port
Cast Aluminum
$1500 pair obo






Patterson Mark III Headers
20" overall height
25" overall length
3.5" exhaust output
Water jacketed
Stainless steel
2" round port
$2000 pair obo








Patterson Single Port Side Header
20" overall height
25" overall length
3.5" exhaust output
Water jacketed
Stainless steel
Cracked and repaired previously
2" round port
$500 obo




Y Pipe
23" centerline
37" overall length
4" output
Water jacketed
Stainless steel
Possibly for small block
$500 obo




Patterson Tail Pipes
Water jacketed
Stainless Steel
60" overall length (has 1" dent)
58" overall length
3.75" diameter
$800 pair obo





Tailpipes
61" over length
60" overall length
3.75" diameter
Water jacketed
Stainless steel
$500 pair obo





Y Pipes
Stainless Steel
29" overall length
24" overall length
3.75" input
5.75 output
Threaded water inlet
$400 pair obo



Patterson Tailpipes
Stainless steel
Water jacketed
26" overall length
22.5" overall length
3.75" diameter
$300 pair obo



Tailpipes
Stainless
Water jacketed
3" diameter
5" flange
29 3/4" overall length
$300 pair obo





Patterson Tailpipe (one single pipe)
Water jacketed
Stainless
3.75" diameter
29 3/4" overall length
$150 obo




Mercruiser Big Block Flywheel
$40 obo



Mercruiser Big Block Intake Manifold
Rectangular port
Brass inserts
GM # 6269318
Dual pattern
$100 obo

Seller is open to any and all offers!

I'm pretty sure the first manifolds are Drakes. There was a pair for sale on here a few years ago.

very certain they're early drakes later made by Keith Eickert.

Take the riser off and you'll know for sure. They're pretty decent. I bought a set off eBay but never got delivered.

Thanks for the clarification on the first set of headers. Can't edit post for some reason at the moment.

This stuff is just taking up space, seller willing to look at all offers. Feel free to PM me.

This stuff needs to go. Make an offer and they're yours.

Posted on eBay now in auctions.

are the the stainless straight tails 3" ID. didn't know they made them that small please check them again and send me a picture of the end with with a tape measurement, Thank you very much, my email is,,, [email protected]

those red exhaust is from Torque Engineering the same company that made the V 12 engine in Elkhart IN.