Pulling motor from 288
04-06-2016 | 07:07 AM
#1
Thread Starter
Registered
Joined: Mar 2005
Posts: 83
Likes: 2
From: Chesterfield, Va
Pulling motor from 288
I'm getting ready to pull my motor from a 2000 288 in order to get a few things done. Just wanted to ask anyone who has been through this if there are any "gotchas" or prescribed order of disconnecting/removing items to ease the pain of pulling the motor out? I'd rather not reinvent the wheel if I don't have to.
Been a while since I posted.
Been a while since I posted.
04-23-2016 | 10:31 AM
#2
Thread Starter
Registered
Joined: Mar 2005
Posts: 83
Likes: 2
From: Chesterfield, Va
Just an fyi/update. Pulling motor was a piece of cake. Two hours of disconnecting things and it pulled right out. Used a crane on the back of a truck. No special order or any "gotchas"
Took a lot of pictures beforehand though.
Took a lot of pictures beforehand though.
04-24-2016 | 07:32 AM
#3
Registered
Joined: Dec 2009
Posts: 711
Likes: 37
From: Florence, Kentucky
