Got some JL MX770's on the way. I may need some LED spacer rings due to the depth of the speakers.
I found a couple on EBAY but want to see what else is out there.

Thx in adv.

I've had great luck with Blast LED rings in my last two boats. No problems at all.

Good to hear you not having any issues with the Blast rings. I just ordered a pair. Thx!

Just an FYI, I ordered these from Amazon,for the second install and it was a lot easier to solder to the light rings on the bench. Cut the install time in half.

5-Pack LEDJump Black 4 Pin Waterproof Male Female Connector Cable RGB LED Strip with Rubber...
by LEDJUMP

What needs soldering on the ring?? I assumed the rings had wires coming off them and I would solder the wires into my existing logo light wiring.
Will I need some kind of special connectors?

You are correct, there are wires coming off the rings. There are 4 wires, I just used the connectors to speed the install, pre-made averything then just pulled through and connected.

I used these on a 7.7 install a few years ago. There may be better options out there now, however.

http://store.earmarkcaraudio.com/Xca...cat=265&page=1

Key point is to pre-drill the acrylic, and be careful when drilling - I broke one due to being too anxious with the drill bit size (start small and increase size).