I have full hydraulic Steering. Latham Rams, Charlyn helm capped steering pump with billet pulley. Have speed master or TRS wing plates transom brackets TRS tie bar. Most hardware is there but you will need some.
2500 shipped. Can do bravo if you want. I have back caps for single and twin.
Dual cooler bell. One is real nice and clean 600 shipped
One cooler bell is pitted and has 1 cooler only. 250 shipped
Cat tie bar I will get C/C for any one interested 300 shipped
SSM trim pumps 400 for the set shipped
Small drive res bottles 30 each or bother for 50 shipped
Plug in to drive line adapters SSM with inner plate 1000, may have 2 I will look.
I have TRS trans redone 2 years ago. 650 each 72C
I have HD and HD torque plates for 72C
I have fresh merc trans never ran 350 each
Pair of solid hub 25P mirage non plus 400 shipped pair
Set of L and R TRS drives lowers cracked 800 paid they were recently rebuild but lower cases are toast. [ATTACH=CONFIG]564032[/ATTACH][ATTACH=CONFIG]564033[/ATTACH][ATTACH=CONFIG]564034[/ATTACH][ATTACH=CONFIG]564035[/ATTACH][ATTACH=CONFIG]564036[/ATTACH][ATTACH=CONFIG]564037[/ATTACH]

What is center line measurement on tie bar

I will have info 1st thing tomorrow
Thanks

71 1/2
Has adjustment in and out

What is the throw on the steering rams?

Will measure tonight sir
Thanks

17 closed 26 open
9 stroke
Thanks

Better cooler sold
Bottles sold
Thanks

Obo

Latham system left and 1 full hydraulic hynautic set