28 skater rear hatch
03-25-2018 | 03:50 PM
#4
Registered
Joined: Sep 2006
Posts: 1,705
Likes: 872
From: Cedar Rapids Iowa, LOTO, Cape Coral Fl.
I have the race hatch for a 28 that could be cut down to whatever length you wanted to make a rear hatch. I do not think that there is a “standard” size front to back.
03-25-2018 | 06:42 PM
#5
Thread Starter
Registered
Joined: Jun 2016
Posts: 37
Likes: 0
From: Elburn, IL
03-26-2018 | 11:07 AM
#6
Registered
Joined: Dec 2013
Posts: 516
Likes: 128
From: houston texas
have had 2 28s here that had hatches from new
and are 291/2 front to rear and bulkhead wall is in place on top of the factory floor liner raised area at the 90deg bend
so that would be the more common length for a factory hatch/ bulkhead wall to match the floor liner glassed flush
and are 291/2 front to rear and bulkhead wall is in place on top of the factory floor liner raised area at the 90deg bend
so that would be the more common length for a factory hatch/ bulkhead wall to match the floor liner glassed flush
Last edited by johnmiffco; 03-26-2018 at 11:12 AM.
