any designer out there???
11-01-2002 | 04:46 PM
#1
Thread Starter
Registered
Joined: Oct 2002
Posts: 791
Likes: 0
From: Lighthouse Point Fl
any designer out there???
lets hear some of the things that you designed and made for baots...
i'll start... design full size swivel bluster for scarab and a pair of bluster seat that will work in a douglas skater and profile cat..
i'll start... design full size swivel bluster for scarab and a pair of bluster seat that will work in a douglas skater and profile cat..
11-01-2002 | 05:02 PM
#3
Guest
Posts: n/a
AHHH I worked at Team Scarab for 12 years and I
can say one thing for sure
Larry Smith would not allow any type of swivel
seat in a Scarab, All seats had to hard mount to
the floor.
A Second strange thing is
that he would not put a
Drain plug in any boat
Race or not that was built
at Team Scarab.
Im not trying to be a smart ass but thats just
how he is.
Mike J.
can say one thing for sure
Larry Smith would not allow any type of swivel
seat in a Scarab, All seats had to hard mount to
the floor.
A Second strange thing is
that he would not put a
Drain plug in any boat
Race or not that was built
at Team Scarab.
Im not trying to be a smart ass but thats just
how he is.
Mike J.
11-01-2002 | 07:08 PM
#4
Thread Starter
Registered
Joined: Oct 2002
Posts: 791
Likes: 0
From: Lighthouse Point Fl
they were out of a 47 smith.. never changed anything about the seat that he made just made it beter...all the swiivel is mounted harder than he every did below deck.. sorry i am dyslexic
Last edited by CustomRigger101; 11-01-2002 at 07:15 PM.
11-01-2002 | 07:14 PM
#6
Thread Starter
Registered
Joined: Oct 2002
Posts: 791
Likes: 0
From: Lighthouse Point Fl
Originally posted by Steve 1
101 forgive Cat
More points around here are awarded for “Originality” and” Intent” than spelling!
101 forgive Cat
More points around here are awarded for “Originality” and” Intent” than spelling!
11-01-2002 | 07:20 PM
#7
Thread Starter
Registered
Joined: Oct 2002
Posts: 791
Likes: 0
From: Lighthouse Point Fl
ok here's another for you... say a guy nails a log.. everyone hits something sometime.. take our racks and lay them out and cut them back.. down the sides,, drop the back half.. cut back the your beams.. where am i going???????????
11-01-2002 | 09:07 PM
#8
Joined: Aug 2001
Posts: 322
Likes: 0
From: here
rigging on your own SUCKS!! We had to reposition the sea strainers a couple of times, drill bigger holes for the exhaust, replace guages, drill new holes for the port engine's motor mounts. I do not envy you if it is your profession.
11-01-2002 | 09:20 PM
#9
Registered
Joined: Oct 2001
Posts: 1,915
Likes: 0
From: Toledo Oh
About 8 years ago I replaced all the teak on my old Scarab with 3/4 inch thick cuting board from work. Looked very cool and easy to work with. Now they are selling the stuff as Starboard for about 4 times what its worth. You can buy it from a butcher supply house for a fraction of the cost as West or BoatUs.
