Two sets of Ilmor Straight-back headers.
#4
Thanks Richard. I just put this post up there to see if there was any interest in them. They have been sitting in the back of my storage unit at Lake Cumberland for 10 years.
I got them here off OSO 10 years ago with a set of Arneson's that I am still running on my ZRC. My rigger wound up using downturn headers on my Donzi ZRC so that he could accommodate a swim platform, so I stuck these straight-backs in my storage unit and they have been sitting there for ten years.
If these headers pressure check ok they literally should only have test time on them. They came off a failed 38 Fountain cruiser project with Ilmors and Arnesons. The boat wouldn't come on plane because the Arneson drives were placed too high. The owner got pissed and stopped paying the bank, didn't winterize the boat and cracked the blocks and let the bank take the boat back. At the time the seller who bought it from the bank said the headers checked out fine - but I'll have them professionally checked.
Now that I know there is interest in them I'll get them inspected and pressure-checked and get back to everybody.
My email is [email protected] btw.
I got them here off OSO 10 years ago with a set of Arneson's that I am still running on my ZRC. My rigger wound up using downturn headers on my Donzi ZRC so that he could accommodate a swim platform, so I stuck these straight-backs in my storage unit and they have been sitting there for ten years.
If these headers pressure check ok they literally should only have test time on them. They came off a failed 38 Fountain cruiser project with Ilmors and Arnesons. The boat wouldn't come on plane because the Arneson drives were placed too high. The owner got pissed and stopped paying the bank, didn't winterize the boat and cracked the blocks and let the bank take the boat back. At the time the seller who bought it from the bank said the headers checked out fine - but I'll have them professionally checked.
Now that I know there is interest in them I'll get them inspected and pressure-checked and get back to everybody.
My email is [email protected] btw.
The following users liked this post:
thirdchildhood (05-03-2021)
#7
Yea I wasn't clear in the ad. They are for Ilmor 710's - 625's-550's. Not sure about 725's but I think all of the V-10's use the same headers.
I actually listed them here on OSO years ago but I got zero responses on them. I've been waiting for months and months on a new Port downturn Ilmor header for my Donzi, and they are backordered and not cheap. That's what prompted me to see if there was any interest now in these straight-backs.
I actually listed them here on OSO years ago but I got zero responses on them. I've been waiting for months and months on a new Port downturn Ilmor header for my Donzi, and they are backordered and not cheap. That's what prompted me to see if there was any interest now in these straight-backs.