I have 2 intakes for 9.8 rec port 4500 flange. These are port to match which most prefer pfl-206-j-9r.

500.00 ea shipped.




http://www.competitionproducts.com/P...o/PFL206-J-9R/

Just curious why you are selling. I bought a pair of these last year to replace Brodix HV 2001's but haven't run them yet.

I let my head guy decide between these and the hv2001’s. He was adamant about using the profilers so I ordered them. Both were going to require porting and raising the floors but after comparing he felt the Brodix would require less time. He still feels these would make more power and if they don’t sell I might have him finish one and do a in boat comparison.

Basically time was of essence.

Sounds good keep us posted! I'm hoping to pick up some power below 5800 with the Snipers. Neither old or new manifold floors were filled so should make for a good comparison but I'm not going back on the Dyno.

My dyno got delayed due to VTP clearance issues so had to tear down the short blocks and fly cut the pistons. ****ty deal. Chit happens!!!
I’m tuned to run 6k-6,300

Ttt