Probley not but does anyone have or know of a plasma arc/ cutter for sale or trade in NW IND/ILL area? Not a small one but to cut quarter to mabey half inch material. Thanks, Nick

you will love it use one every day ours is a esab 875 cut 1in thick today it's rated at 3/4 doint like themaldinamic or thearmal arc esab or miller lincon

Try Mittler supply. They use to carry welding supplys and if they don't have it they can most likely steer you in the right direction. I just pulled up there website and it looks as if they have grown quite a bit from my days back in South Bend. Mittler Supply If you don't have any luck there you might want to look at www.weldingmart.com

Good luck

make sur eyou get a 220 volt....some 110V claim to cut 1/2 " but forget about it...as said Esab , Miller , Lincoln in my opinion

I know where to get new ones but it sounds like you want a used one. Right? What power supply are you going to be using?

Wish you'd asked about a month ago.
My company just auctioned on off. It went real cheap.
This one would've handled 1.5" material.

thanks guys, ill look at that site, quiet... yes used, but open for sugestion, 220 single, but am willing to consider three phase, I know where to just walk in and leave w one, but was hoping to find a deal, you know how it goes, thanks again, nick

CHECH IN E-BAY , LAST TIME I LOKED THERE WHERE OVER 100 LISTED NEW/USED