Hey guys my bolsters just arrived the other day and now I am trying to figure out were to put them so that I can continue on with my fairing and dash project. What I am looking for is the measurement from the front of the dash to the front of the seat and also the distance from the steering wheel to the back of the seat (were your back rests into). Any help would be great so that I can get back on this thing

Jon

Are you sure you wouldn't rather have my address to ship the bolsters to?

It's raining right now, but it has been intermittent all day, when it stops, I'll get up in there and measure for you.

I'm working on replacing the lines to the k planes in between the rain. I got my rounded off one out finally. I took the ram off, cut the old hose, then drove a six point 9mm socket on it, hooked a 15 inch crescent wrench through the handle of the socket wrench and twisted it out. It was plumb easy.

Aint they fun Cuda!!! I would love the measurements off your boat as the dash should be the same. Thanks

Jon

Here you go Jon, from the very front of the seat (at the armrest) the measurement is 10.5".

From the front of the dash to the back of the seat is 32".

From the front of the foot rest to the base plate on the floor is 21".

I took this measurement in case yours didn't have the footrest. From the front to the leg is 30.5".

Before everyone jumps on me abou the leaves in the boat, they all blew in today while working on the boat. It's windy and cold here today.

If you need any other measurements, I'll have the boat uncovered until about 6 pm. I'll check back before I cover it.

LONG SLEELVES AND NO SHORTS ,,,, whats up with that
I thought you were in Florida