Bravo1 Lower Unit - Torque Spec
06-03-2003 | 02:52 PM
#1
Thread Starter
Registered
Joined: Feb 2001
Posts: 538
Likes: 0
From: Portage,IN
Bravo1 Lower Unit - Torque Spec
Anybody out there use a torque wrench to fasten
the lower to the upper drive unit on a BravoOne?
If so what would that torque measurement be?
"Sure do like those french fried 'tators" Emmpphh!!!
the lower to the upper drive unit on a BravoOne?
If so what would that torque measurement be?
"Sure do like those french fried 'tators" Emmpphh!!!
06-03-2003 | 04:24 PM
#2
Ginger or Mary Ann?
Joined: Oct 2000
Posts: 11,030
Likes: 9
From: L
The torque specs are 35 ft lbs. Keep in mind that a crowfoot would be needed for the recessed nuts, and the torque value spec need to be compensated for such.
I just tighten by hand, never any problems.
Your thinking to hard.
I just tighten by hand, never any problems.
Your thinking to hard.
__________________
Some people are like Slinkies - Not really good for anything, but they
bring a smile to your face when pushed down the stairs.
Some people are like Slinkies - Not really good for anything, but they
bring a smile to your face when pushed down the stairs.
