dont bill me, youll have to get ahold of my mom for that, and whats with this grasshopper stuff??? can you fill me in on this Dave

lol . . . look it up. Wikipedia or something :drink:

Grasshopper ???? Is it a chick at the club ???:cool:

that chick is ridiculously hot . . . .saw her in some ebay ads for boats :drink:

Things that make you go mmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmm mmmmmmmmmmm:ernaehrung004::ernaehrung004:






C'mon now rediculosley hot :eek:

good luck :eek: Thanks Dave just put # 2 mask on Today and sprayed Silver for the Diamond Plate Base :ernaehrung004:

a few more


Thanks again to Glass Dave for all your help :ernaehrung004:

SWEET! . . . . . any more pics of that chick in post #43? :D


just thought of something else. When you are done with the diamonds only pull off the #2 and #3 mask leaving the largest outer mask, that will allow you to double check the 1/4" edge/border highlights. If for some reason you want to change it i can cut a mask to block off just the main diamond plate part and you can correct it. I still have the cutfile with registration marks in place.


Man this is great . . . I'm just gonna phone in graphics from now on . . . this is way easier :cool:

Sounds good Dave , if i have to i'll probably just use some 1/4" tape if i have to because those areas i talked about werent all that huge. Ill just see in the end when i pull it, off. thanks for your help its moving along pretty smooooothly now .

P.S. stop calling me so much at the shop, my dad thinks im not gettin anything done and says i'm not moving fast enough :cool-smiley-027::party-smiley-048: ... grasshopper

lol :drink: