|
Originally Posted by tzrider
(Post 3516921)
Damn Dave, I forgot you bought those. I feel a little sentimental now...lol..
|
Originally Posted by JIMKID Motorsports
(Post 3517232)
what is the current status
dash wiring, find and buy and install new fuse blocks for 4 engines behind dash, hook up gps speedo kit run control cables thru bulkheads and connect at both ends finish connecting gas tank fill and vent hoses both sides, complete pickup fittings at top of tank measure gas tank for correct depth and order senders and install finish routing engine harness, power supply wiring, water pressure hose for guages, etc from back to front thru bulkheads and console, install and wire in fuel pressure sending units and hi pressure fuel pumps re-install engine trim pumps and wiring, come up with a solution for controls at helm wire and install 19 instrument panel toggle switches finish out water feed hoses and fittings and hook up everything to water distributor block and then measure, purchase and connect to engine adapter plates with appropriate fittings and hoses reassemble remaining two outboards, clamps, midsection cans, gearcases, hang on transom. hook up power cables to 4 Optima batteries and hope that I don't see sparks anywhere in the boat:picard1: Install hyd steering cylinders, wing plates, center plates, tie bars, connect hoses to cylinders, reconnect hyd steering hoses fore and aft bleed steering system install new cockpit carpet install new upholstered side panels install front and back seats probably a long list of misc. items that I will remember later drink some beer and gaze at it for a while |
Are you running power steering ?
|
no, just standard hyd
|
i know its going to be a workout steering
|
Its not hard to interface a Verado electric/ hyd pump . That is my plan after talking to a few that heve P.S . If you decide I have info to help you out .
Larry |
Larry, can you explain how to interface the Mercury Verado electro-hydraulic steering systems into racing outboards steering systems
|
Ancient Chinese Secret !!!
|
1 Attachment(s)
I recently received my throttle/shifter controls back from Latham. They did a great job of converting my old trip engine set up to quads
|
Looking good, Gps shipping tomorrow!
Did you talk to Latham about the bezel? I can bring them a unit if you need me to. |
| All times are GMT -5. The time now is 01:49 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.