Can you beat the 25 K Noli offered ?? I paid 23 K and worked pretty much non-stop for three years !! Shaun( STR ) is just finishing up my lowers and my 375 Stokers are ready to come home . How much HP per engine were you running and how fast with this pile of crap ? I figure 105 with pair of 375 HP efi stokers

Larry

That is all cool stuff!:cool:

Thanks ! Does anyone know of pair Imco rams and 51 inch tie bar for sale ? must be Imco

Awsome trailer! Are you doing the work yourself on it??

Thanks ! Yes all of it except the galvanizing

260 each. With old school prop technology itd run 106. RE4 in the middle , cleavers on the outsides. This was in race trim, i bet with jackplates and better props itd run low teens. Stop calling my baby a pile of crap! :lolhit:

A few people asked how I move this hunk of crap around , here is a pic . 16x 10 x 1/4 alum with a few layers of closed cell foam rubber . The 2x 4 wood is just a simple link right to left side . This dolly is only used to paint deck as the bottom of sponson is 1 inch off ground . When paint is complete boat will go back on standard boat dolly

Painted my composite shifter arch which I made , it has cast in stainless inserts so that there are no visable screws .

The trailer is almost ready to send to Galvanizing but I have to make a few changes , like drill 85 5/8 relief holes so that pre-wash and then 850 degree Zinc ( hot dip galv ) can flow through . The ladder is an issue because I'm going to flip traler over to drill some holes so I cut ladder posts and welded on [re-drilled plates so that after galv it can bolted together . In the pic plate was in mock-up and not squared up

Larry

A Few More Pics Of Custom Boarding Ladder That Had To Be Plated Ro Make It Easier To Galvanize

A Few More Before When Tape It Up Ro Paint Graphics . Shaun Torrente Said Engines And Lowers Are Ready To Ship

hay looks good i took my diomond plate to my anodizer and had him clear coat them and they worked great