- - 28 Skater Help
(https://www.offshoreonly.com/forums/skater/259713-28-skater-help.html)
Double Rigged
08-09-2011 01:56 PM
Originally Posted by KEVLARKAT32
(Post 3473799)
Rigging my hunk of crap real soon , curious , how do we measure this ?
you measure between front edge of the nose cones as one measurement. Next measure the center from shaft to shaft. I use the middle of the dimple in the shaft as a reference.
If you are at a zero toe both dimensions will be the same. If you are spinning out the measurement from shaft to shaft will be a little less than the front dimension.
Spinning in is the opposite.
kaama82
08-09-2011 09:18 PM
I take it we should set up our I/O like this too??????
Double Rigged
08-10-2011 06:26 AM
A drive is a drive. No matter if I/O, or Outboard. Same theory applies.
kaama82
08-10-2011 08:40 AM
Originally Posted by Double Rigged
(Post 3474797)
A drive is a drive. No matter if I/O, or Outboard. Same theory applies.
