Crack in Bilge!!!!
 

I confused on what to do!!:confused:

I was cleaning my bilge yesterday and I found a crack in the bottom. I checked under the hull O/S but I couldn't see anything.

It's on the starboard side between the stringers.
There is a box section that runs between the stringers from the center to the O/S of the boat about an 1.5" - 2" high just under the front part of the motor. The crack is above the box section and it goes around the box section.

Should I call Sunsation?
Should I take the boat there?

A lot of times an overlayment of the laminet that has been covered with gel can look like a crack, Or if there is a slight void between the gel and the laminet commonly found on inside radias the gel can crack, But if that is not the case contact the factory

I know it's a crack because I can get my finger nail underneath it and it has a little bit of flex.:( :( :( :( :( :(

:D :D :D I just got off the phone with Barry he told me to bring it by and he would take a look at it. He said it didn't sound to bad and it would take about 45 minutes to fix up.

Very happy customer!!!!:D

VERY HAPPY SUNSATION OWNER!!!!
 

:D I am happy to say that I dropped the boat off at Sunsation yesterday at 6:00 in the morning and I picked it up fixed at 5:00 pm the same day.

:DNow that's what I call service. I want to thank everyone at Sunsation for getting this done in such a timely manner. My hat is off too you.

Thanks again, a very happy Sunsation owner!!! :D

i tell ya,,,,those guys are cool...now if i could only get them to......:D