|
Thanks for clarifying, I guess I understood half of the towing joke. Good for you, sounds like it is running well, Tsunami is a cool boat.
|
Originally Posted by pinball
(Post 3961015)
it was a joke. Responding to theTOWING joke.monday we went out ran 36 s boat would not go at all. Went back pulled out put 32 s on .so this is the first time out with boat running properly props pump ect ect. Ran great had a blast still learning as we go did run 96 8 in ocean boat was not done yet.not opened all the way.100 plus will be done once i grow a pair.
Innnnnnteresting.. ;) |
billy to be honest with you we had the boat doing 77 .4 after pulley change .then put imco -2 and went down 72.3 but also had prop repairdsuck job. that screwed every thing .but would still like you to adjust computer.thanks dan .now we also now have 5 blade maximus.
|
Originally Posted by sutphen 30
(Post 3959536)
Is that the same drive that only let it get to 72.4mph?I was on the boat when it ran its fastest,76.4mph.never had time to retune the top end on it.
|
Originally Posted by 47EXCALIBUR
(Post 3961009)
im happy that someone got some use of those engines. those engines did push the 47 Excalibur to 60.5 on gps(new engines in the boat push her to 75+) in a boat that weighed in at 24k lbs so triple didgets in a 33' sutphen should be no problem.
|
Originally Posted by pinball
(Post 3961720)
tell hank to stop telling storys out of school . dan
|
heading out tomorrow night, ready to do a buck.
|
Originally Posted by pinball
(Post 3964671)
heading out tomorrow night, ready to do a buck.
|
Originally Posted by RFCB
(Post 3941929)
We never had 28's when we had it. We had a set of worked 30 Bravo's and a set of worked 30 or 32 Hydromotive Quad 4's. I believe we spun them up to 5400-5600 rpm. The Hydromotive props were faster by a few MPH. What direction are you turning the props? It is faster turning them in.
|
We had pick ups in the trim tabs.. We had a 1/4 turn ball valve on the dash in front of the throttle man's seat for filling or stopping the filling process. Drop the tabs an open the valve and the tank would fill in 45-60 seconds. We had two large pumps that could pump out the water in approx. 45 seconds. The outlets were on either side where the race # is. There was a small vent outlet on the top of the tank that blew water out on the ports side above the rub rail that let us know when the tank was full. If I remember correctly the tank is 42 gallons.
|
| All times are GMT -5. The time now is 04:47 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.