600hp + cheap
 

I have a pair of 540's complete with cmi's and tailpipes / teague oil coolers / 1050 dominators / k&n flame arrestors fuel pumps etc ..........less than 50 hrs ..Dart blocks / edelbrock alum heads ....

And???????

how much are you looking for???

as much as I can get , i was hoping to get 18K a piece as new ones would run 25K with everything i am including .
but they have been sitting in my shop for almost a year so Im open to offers .Bell housings / flywheels / alternators / one power sterring pump / sea pumps / starters / flame arrestors / braided lines / remote oil relocation / Hp6 filter mount / teague high volume oil coolers / oil pans with braided lines to drain oil out from tight location . Heads ported and polished / electric fuel pumps remote mounts and lines ..basically all you will need is engine mounts /couplers / fuel filters and water lines from your transom .. these engines idle perfectly for docking lots of torque can be dynoed ..made 650+

Send me your email address and i will take some pictures of what they look like if they are in your price range .

too much for me.....this is what im using as a starting point
http://www.offshoreonly.com/classifi...o26286-en.html

Good luck with your search , it is definelty a buyers "beware " market ...I do have one 420 mega blower fresh teflon and intercooler c/w carbs and fuel rails sitting around ...

where are these located?

possbily interested, what are you looking for

what is the 420 worth to you ?intake / carbs / linkage tec .. make an offer ..has been sitting in my shop for at least 5 years since I purchased them from BAM marine ...did not end up building blower motors went nasp 540's and have them for sale now , running 525's from factory ..



located at A-bay new york at 1000 island bridge

How about a teague XR lower unit?