Looking for Hydraulic Roller lifters
 

I just put my Gen 6 454 motor together and the cam has 611-613 lift. The stock lifters were dirty and stuck so I rebuilt them. After thinking about how dirty the lifters were and hearing that my cam has to much lift for stock lifters I think I need to replace these factory lifters. Does anybody have a good set of either the Crane or Morel lifters they are looking to get rid of? I think the Cranes are 300 thousandths taller so with the big lift you don't have to worry about the lifter going below the dogbone.

Buy NEW lifters. Saving a few bucks is not worth the risk.
Call or PM rmbuilder.

i got the cam from RMbuilder so we have already discussed this.

I have a set in the garage which I bought used off here and just had them for back up. I was told they where used dyno time only. Make me a offer.

They are crane and I ended up suing morel lifters.

Suing or using?


:evilb:

Using :lolhit:

How much do you want for lifters? If I had to offer, how about 50 bucks plus shipping.

I have 2 sets of Morel lifters that I bought through Bob. 1 set with 2 hours time, like new. 1 set rebuilt in 2009 with 50 hours. Like new set $300. Rebuilt set $175.

Thunder, who rebuilt the lifters. PM me and let's discuss payment and shipping.