240 Baja sport project
 

I have a 240 sport that just had the floors and strings re done. They were vacuum bagged and beefed up. Has a newer fuel tank some gauged updated. Transome reglassed to cut a higher X if wanted. All the interior is there with the sliding glass plexi door for cabin. Has foot rest for drive and passanger. Could use some new wood for upolsery in cockpit. Throttles steering and ram still in boat. Boat needs to be put together but very solid hull and clean.
3700
I have a transome assembly for it- 800
540 10 hours EFI- 8000
Blower for 540- 2600
-10000 complete bravo drop in

baja sport240
 

where is the boat thanks mike

Is that Party's boat?

No not party Arti.
Boat located in Fall River mass

Is that the boat that was on South Jersey CL forever for like $1500? Did you finish all of the work the guy said it needed to the floor and such?

It was 2k and I did finish it up. It was clean as he said it was.

10000 is for the 540 with blower setup all the parts ready to go correct?

10 is for a bravo ready blower motor for a bravo. Compete setup engine blower fuel system and reg. piping intercooler the works.

There is a 468 I just finished also available for this. I have a trailer and older bravo 1 for the boat also. Have a few props laying around also if needed. Rear bravo offshore plate included if you grab one if the engines