B&M 250 Blowers + Accessories
 

They're are two blowers hence the separation of the different angled photos. I am looking to sell them as a set but will separate if offers are made. A few pieces are missing such as a few pulleys but majority of the equipment is there and this is how it was purchased. Was for a planned set of motor builds but that idea has been shelved and the need for these is gone. This is all the parts I have in relation to the blowers, so what you see is what you get basically, I have no other parts in relation to these blowers.

They were purchased by my father who is no deceased, so from what I remember from the top of my head. One of the bottom crank pulleys is missing, the intakes, and carbs to make them complete.

I am open to offers via pm. They are located in Canada, but I have no problem packing them up and shipping them anywhere at your expense.

http://i.imgur.com/gsiGVsE.jpg

http://i.imgur.com/msW2cyR.jpg

http://i.imgur.com/bHx35jL.jpg

http://i.imgur.com/x6Q3JbK.jpg (15194 is part number on pulley) Blurry Picture on that sorry.

http://i.imgur.com/ANQj7fb.jpg

http://i.imgur.com/usxyIdO.jpg

http://i.imgur.com/4fRRNZH.jpg

Think you could do me a huge favor and measure the intake flange thickness where it bolts to the head??

@lil red: I won't be near them until next week end. Tell me how and where I'm going and I'll get it measured. Currently in CFB Borden so I'm about 4 hours away from them at this present time.


Inbox cleared again as well.

Tt

Maybe I missed it but are these new or used? used I assume..... Big block or SB intakes??

No intakes.

Used, but from what I remember, one was near new in regards to the teflon.

Tt.

If you PM me please clear your Inbox.

ASKING 3500$ plus the ride. Make an offer.

I am at the blowers and parts for the next week and a bit, so I can measure or look at anything (photo etc) for anyone.

I see intakes in the picture and you are saying no intakes?