Offshoreonly.com

Offshoreonly.com (https://www.offshoreonly.com/forums/)
-   Swap Shop (https://www.offshoreonly.com/forums/swap-shop-253/)
-   -   24P Bravo I 4 Blades (https://www.offshoreonly.com/forums/swap-shop/301384-24p-bravo-i-4-blades.html)

nailit 08-28-2013 09:00 PM


Originally Posted by fleg1 (Post 3984891)
I'm betting that you loose cruise mph after labbing the 25's... Your motors need to run at 5150 at wot there is no way your going to be able to pick up 700 rpm by labbing the 25's.. Your best bet would be to lab the 23's get the rpms up to where they need to be add some cup to them to carry the bow, your cruise and WOT speeds should both pick up some mph..

The plan would be to take a lil pitch out.. to 24ish " and lab to get some more rpms.. since I own the 25s.. would be cheaper.. I still need to test the props again spinning in with load. Went out by myself once for a short spin and turned to 4400 without aggressive trimming o i need to get to around 48-4900 in this heat so when it cools down I am not all over the rev. Should be able to get 5-600 by repitching and labbing without sacrificing too much cruise.

Thanks

Nightlife1970 09-01-2013 07:58 PM

Ok 4 people on boat 2 coolers plus a raft. 1/2 tank of fuel. Ran 50 at 3500 and 57 at 4000. Was only able to get 4400 and 63 wfo in totally flat watet.

nailit 09-02-2013 09:51 AM

Thanks for the info, but that's my normal load and speeds with my 25p m+. I prob couldn't push them any higher.

Someone able to spin 25p m+ already would benefit from these 4 blades and prob not sacrifice any top end.

I guess after they a ounce me as the winner of bblades contest, I will lab mine :-)
Thanks again NL!


All times are GMT -5. The time now is 10:58 AM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.