Tie Bar off XR drives - 32" center-to-center.
 

I have a nice clean tie-bar that came off my boat that did have XR's on it. It is 32 center to center but does adjust some. $150 + Shipping.

[ATTACH=CONFIG]515674[/ATTACH][ATTACH=CONFIG]515670[/ATTACH][ATTACH=CONFIG]515671[/ATTACH][ATTACH=CONFIG]515672[/ATTACH][ATTACH=CONFIG]515673[/ATTACH]

How big is the bolt hole?

Keith, it's 5/8.

Ttt....Keith?

Is the measurement at the current set up, meaning you can adjust the width in a little on the one end? Need 31.5 for my set up.

It is adjustable and it appears its adjusted out pretty far. I'll adjust it in and show you a measurement . It very well might get into 31.5".

I measured again and took pictures with a tape measure. It's 31.75" exactly center to center of bolt holes. There is .75-1" of adjustment showing on threads. Meaning it could easy adjust in to what you need, but may not adjust out greater than the .75-1" if someone needed lets say 32.5". It should work fine for you. I'll post pics in the morning.

Katanna, Here are some pictures showing how it could easily adjust to 31.5".

[ATTACH=CONFIG]515962[/ATTACH][ATTACH=CONFIG]515963[/ATTACH][ATTACH=CONFIG]515961[/ATTACH][ATTACH=CONFIG]515960[/ATTACH]

P M sent

Sold, thanks!