525SC Part Out
 

Parting out my 525sc. Bottom end was freshened end of 2011. has prob 100 hours on it. Port side cylinder head corroded thru and broke the intake valve. Piston does not appear cracked but has some damage to the top.

Cam ia comp cams hyd roller grind xr271hr-12 .224/.232 @ .050 .591/.601 Lift on a 112 lsa, Isky Hyd Roller Conversion Lifters with link bars, isky chrome molly pushrods, crane gold rockers 1.7 ratio and stud girdles. $700 this combo made 570hp and 600 ft lb tq

Weiand 177 Blower with 1050 Dominator. Pro systems went thru the carb in 2010. Idled perfect. Have the crank pulley, intake and belt. Rolling the blower by hand i can feel a little slack, prob needs to be gone thru. Was running great. $1200

Short block with heads. Block is .060 over, valve springs are comp dual with dampeners and stainless retainers. $500

Parts are located in South Louisiana near Baton Rouge, Can Email pics if needed. You can reach me at [email protected]

Also have a set of Hardin Marine Tall Valve Covers. Powdercoated Blue. $200

bump. Open to offers

Also have a set of thru hull tailpipes for lightning headers. $100

you have p.m. thanks leo

how much to ship to 49344. thanks leo

pics of valve covers,blower, and are you going to sell lightning headers [email protected]

I will check on shipping cost for ya.

The headers came on a motor I bought, and came with the long tails, but they wont work with my boat. Just looking to sell the tail pipes. and I will get some pics of the Valve covers after work. do you have an email I can send them to

pics of valve covers and blower setup to [email protected] thanks

split shipping an I will take it thanks leo