330 parts motor
 

$400 plus shipping for the whole motor
Bell housing $100
Coupler $150, splines like new, has the steel snout.
Old style tbolt 4 ign with engine harness $60
Distributor with cap rotor and wires $75
Ps pump with bracket $100
Starter $25
Alt $25
Motor is complete so if you need something let me know.
[email protected]

Jamie, Can you get me the part # off of the engine harness and is it 9 prong 3 large and 6 small? number should be on the square four bolt flange or on a white tag on the loom. Also, do you have the circuit breaker and solenoid on the bracket? Thanks, George

I have all of that George, ill check the part number now

8494111a5 9 pins

Need 84-86683A2 for the 78 Excal. Do you know what year it is and was it inboard or i/o?

88 I/o

If pin # 1,4,6 are large brass female, it might work. Too bad Mercruiser couldn"t standardize the plug connections....that would be too easy huh!

This has been the only one I ran into that was different.

Hi Red, is the block a 4 bolt by any chance?? I am looking for one and a steel crank to...

is it a gen 6 roller block