Cutting Edge 22P 5 blade
 

Cutting Edge 22P 5 blade prop. 500.00 [email protected]

What did you have this on? Would it make sense on a 23' Baja with a 6.2? I've always been curious to try a 4/5 blade...

Had it on my 'Four Winns H240 with a raised X. Not sure about your application but it was a great prop for watersports & the raised X.

DId you compare it to anything else, 3 or 4-blade? I'm definitly interested, but am a little nervous to pull the trigger on an 'odd' prop.

Yes I tried Mirage+, Rev 4, Hydro QIV & QIVX, Bravo 1 & a custom labbed Maximus that I had over 1100.00 into. This prop sold me on Cutting Edge props.

opps

ttt

trade for Enertia ECO 23P

Are you unhappy with the midrange of the cutting edge? Just curious why you would prefer an Eco.

I own the first two 5 blades bravo's they every made. Still using both props today. One that I damaged and they repaired has taken a beating over past five seasons as my "trash prop" used in shady water conditions. Runs within 1mph of the other, just higher revs.

You should see excellent out of the hole thru mid-range performance with probably a bit higher slip numbers on the top end because of the 5 blades drag.

If that was a 26P I'd be all over it.. I'm looking for a wake boarding prop, 10 less than my smokin 37P.

The midrange is great. I’ve heard great reviews on the ECO so I’m hoping for the same midrange plus a little more on top.

Ttt

Available in both right and left hand rotation as well as matched sets. Sizing availability from 14 3/4” – 15 11/16 diameters with pitch availability in one inch increments, odd or even from 21” to 36”. Polished or race prepped satin finish available.

Manufactured from stainless one piece castings, then hand labbed, Cutting Edge Series III, 5 Blade Labbed Propellers are manufactured with strength and accuracy in a one off environment. Each propeller is tailored exclusively for the customer’s individual hull type, power and performance requirements. Comes on plane easier and sooner while staying on plane longer, this labbed propeller excels in all areas of high performance. Excellent all around performance is experienced from these labbed five blade propellers including extreme hole shot, very low planing speeds, greatly increased mid-range cruise speeds are achieved without sacrificing top end, making this propeller an ideal choice for High X dimension set ups, extremely effective on air entrapment or tunnel hulls. Larger or heavier boats with higher passenger volumes and loads. Excellent performer for boats that pull water toys and skiers! Cutting Edge propellers manufactures only labbed high performance propellers.

Ttt

ttt

ttt