|
IMCO SC lowers..
I have a pair of Imco SC lowers, -2" that need to be rebuilt. The cases were blueprinted by Wilson. If anyone is interested send me an email or pm..
Thanks! Dick |
pm sent
|
Pm sent
|
Ttt
|
Send a pm last night
|
Send pic & price to [email protected]
|
can you send a pic and price [email protected]
|
email sent
|
3 Attachment(s)
Sorry for the delay in response.. I have not checked my OSO for a while. Intense research was needed for my grandson's Pinewood Derby car.
Back on track. One lower has been sold, back when I first posted this info. Here is are some pics of the one that is remaining. This is a complete lower, with shafts and bearings, etc. PM me if interested. Dick |
Pm sent
|
|
Inbox cleared email sent
|
Thank You! Emailed sent in return.
|
pm sent Thank uou
|
pm sent
|
Still available, if anyone is interested. After taking another look at the lower gears, they are still useable, no pits yet, but worn.
|
4 Attachment(s)
Decided to setup and assemble this lower unit with a good set of used gears, 1.5 ratio . 1 1/4" Merc propshaft and bearing carrier. Includes vertical shaft coupler and Imco cavitation plate. This lower is ready to bolt on and go! It had the Wilson Blueprinting work done in 2010.
Asking $3200 plus shipping. Shoot me a pm or email if you are interested.. Thanks Dick [ATTACH=CONFIG]538383[/ATTACH][ATTACH=CONFIG]538382[/ATTACH][ATTACH=CONFIG]538384[/ATTACH][ATTACH=CONFIG]538385[/ATTACH] |
Is this lower still available and what do you want for it?
|
Originally Posted by Mr Gadgets
(Post 4269151)
Sorry for the delay in response.. I have not checked my OSO for a while. Intense research was needed for my grandson's Pinewood Derby car.
|
I can't believe this freshend and blueprinted lower hasn't sold yet !!!
|
I agree! One of the best deals I have seen
|
Mr. Gadget's, I have a Mercury -2 XR Sportmaster shortie to trade if your interested.
|
PM sent sir.
|
Too bad this isn't standard length.. It wou defiantly be hanging off the back of my boat this summer.
|
Originally Posted by Mr Gadgets
(Post 4277311)
Decided to setup and assemble this lower unit with a good set of used gears, 1.5 ratio . 1 1/4" Merc propshaft and bearing carrier. Includes vertical shaft coupler and Imco cavitation plate. This lower is ready to bolt on and go! It had the Wilson Blueprinting work done in 2010.
Asking $3200 plus shipping. Shoot me a pm or email if you are interested.. Thanks Dick [ATTACH=CONFIG]538383[/ATTACH][ATTACH=CONFIG]538382[/ATTACH][ATTACH=CONFIG]538384[/ATTACH][ATTACH=CONFIG]538385[/ATTACH] |
Hello Dick
I have send Email to you and get yours! Did you get my answer? Best regards, Michael |
Both units are gone.. Thanks!
|
| All times are GMT -5. The time now is 04:15 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.