Latham Full to Helm Twin Bravo Hydraulic Steering
#1
Registered
Thread Starter
iTrader: (2)
Join Date: Oct 2011
Location: Solomons Maryland
Posts: 217
Likes: 0
Received 0 Likes
on
0 Posts
Latham Full to Helm Twin Bravo Hydraulic Steering
$3,500 Or Best Offer
Full kit off ~35' boat with LMD7 Helm and Bravo Brackets
This kit has roughly $1,000 worth of extras that you might not normally find in other kits on the market including:
-Power steering pump (I was told higher pressure but cannot verify) with the top welded shut/modified for external reservoir (v-belt)
-Twin tie bars with a pair of saddles (37" and 33 1/2" or so measured from center of pins)
-IMCO twin pump valve; part # PT13 on Page 63/126 in this IMCO catalog.
-2 Extra power steering reservoir caps (one of which you will need to utilize the twin pump setup, use both if you utilize your existing pump and not the one included)
NOTES:
-No steering wheel or wheel hub included.
-You will need drive studs for for these caps, they are not included.
-You will need a few extra lines to utilize the IMCO twin pump valve, and another banjo fitting for your other pump.
-I cannot guarantee the length of these lines will work with your boat, shorting or adding extensions is inexpensive.
-Shipping will be from Maryland, I would guess 100$ or so to ship to USA.
Thanks for Looking!
Happy Holidays
Last edited by Jordan; 12-10-2014 at 08:13 PM.
#4
Registered
Join Date: Aug 2005
Location: Sydney, Australia
Posts: 46
Likes: 0
Received 0 Likes
on
0 Posts
Hi
I maybe interested in the full set up minus the tiebars and the wing plates.
I am looking for a set up for a bpm centre rudder on an old class 1 race cat.
I will PM you
Thanks
Mat
I maybe interested in the full set up minus the tiebars and the wing plates.
I am looking for a set up for a bpm centre rudder on an old class 1 race cat.
I will PM you
Thanks
Mat