Parting Scarab
 

Two pair of CMI e-top headers never repaired never any issues $1100 per set, tails are modified bravos to fit TRS
Tails not the best but free with headers
External hydraulic steering air over hydraulic, helm, lines, reservoir, cylinders, fittings $1000
TRS steering wing plates $150 ea
Keikhaefer controls $400
Bolsters $1500
Gaffrig gauge set twin engine $950
Fresh water cooling heat exchangers $500 per one volvo one mercury one mounts on back the other on front BBC
All prices plus shipping and OBO. More to come I'm parting out the compleat boat. Scarab III


[ATTACH=CONFIG]541153[/ATTACH][ATTACH=CONFIG]541154[/ATTACH]
[ATTACH=CONFIG]541155[/ATTACH][ATTACH=CONFIG]541156[/ATTACH]
[ATTACH=CONFIG]541157[/ATTACH][ATTACH=CONFIG]541158[/ATTACH]
[ATTACH=CONFIG]541159[/ATTACH][ATTACH=CONFIG]541160[/ATTACH]
[ATTACH=CONFIG]541161[/ATTACH]

Interested in both sets of cmi's. Anyway to show a pic or two of the flanges/collector or are you trying to keep together until sold?
tks
John

[[ATTACH=CONFIG]541167[/ATTACH][ATTACH=CONFIG]541168[/ATTACH]

Gaffrig Monster Gauges are tach, oil psi,oil temp, water temp, water psi, fuel level, fuel psi, volts, two of each, I also have to senders I can pull out of the motors to go with the gauges

Do ypu still have the gauges for sale?

Are you selling the engine cores? Thanks Kyle

Still have the gauges.
Yes I plan on selling the motors, one runs the other has a broke valve and need a rebuild $5000 for the pair with
Out the headers plus shipping, never had salt water run for cooling in the blocks, heads,or intakes.

How much for the right hand rotation trs outdrive.... Can u send me better pic to 786-660-5401..thanks

I have a bravo 1 will that external steering kit work for me? If so how much you asking for it?

The steering will work, but you will need Bravo wing plates for the your out drives. $1000 OBO
I still need to get a pic of the right out drive I'll get one in the AM.
Make offer on whole boat still together, listed for $7500 on CL no trailer. $2500 for torsion trailer will not sell till boat is going

May be interested in the manifolds/Headers. Would they work w/ Bravo 1 & Corsa Captains Call Diverters? Are these a Good HP increase for a Mild 454 over stock Cast Manifolds, besides the weight? - Thanks

The headers will, but you will have to buy the bravo CMI tails with the captain call turn down, these tail pipes will not work.
The hp gain will not be noticeable, the weight loss will be. A good rule of thumb is every +100hp= +10mph or close

Do you still have the steering and exhaust for sale?

Yes steering and exhaust is still for available

I sent you a private message

All interested Party's need to clear IM boxes, hblair. And gunny

Cleared, sorry.

Interested in selling one of the distributors?

How much for 1 set of gauges?

Still got the exhaust? I've run into a snag with my 496 setup and yours may be a better direction. Thanks.

How about some of the screws that hole the windshield to the upper rail. A few of mine have worked loose and are gone.

Headers still available??

Do you still have the dash switch panel? If you do can you send a pic to 248- eight eight two- 8953

Are the steering rams available?

What are you doing with the engines?

Are u interested in selling one of the DUI distributors