Bravo 1 XR drives 1.50R
 

I have 2 Old style (not sweptback) Bravo 1 XR drives available. They have a 1.50 ratio. They are low hour freshwater units and have drive showers.
Looking for 5k obo each or 9k for the pair. Prefer local pickup.
Indianapolis IN area

I have tried PMing you several times, but for some reason it won't go thru....so, Just had a few questions about the Bravo 1.5 gear ratio drives, please....

What year are they?...also, what are the serial numbers for each drive?

What is the length of boat they came off of?

Are you the original owner of these particular drives?

Have they been rebuilt? If so, what parts were used and who or what company rebuilt them and why and do you have the receipt with serial numbers?

Do they have the low water pick-ups on the nose of the drives?

Have they been repainted?...or do they need repainting?

When you say; "low hours", how many "low hours" are actually on these drives?

Do you have any photos?

Why are you selling them?

Thank you for your time

http://i1145.photobucket.com/albums/...psu4pcczu6.jpg

http://i1145.photobucket.com/albums/...psxilygjbd.jpg

http://i1145.photobucket.com/albums/...psor3yj4ir.jpg

Drives have approx 100 hrs on them. Factory paint, don't need painted. Drive showers included. Factory assmbly tags still on them, but can't read numbers.
I believe they are 99 or 2000 models, pulled from 32' V-Hull with carbed HP 500's, planned on using on another project that isn't going to happen. Have a pair of factory back caps if you don't have imco style steering that uses a steering cap. Nice pair of clean drives. Gear oil was clean with no metal when drained to pull caps.

I am seriously in the market and looking for a set of Bravo 1 drives for a project I am doing....and checking with another source for drives also but, how far (in miles and in time) are you from the Michigan/Indiana state border line near Michigan City?

Looks like I'm 146 Miles / 2:45 from Michigan City, or 120 Miles / 2:10 from South Bend

Nice drives...


How the hell is that 1 inch PVC stand holding up 130 pounds? Seriously, is that photoshopped? There is no way thats real.

Its real. I put some "t's" on the open end of the feet for extra stability, but It holds just fine. No flexing that I noticed, actually felt pretty solid.
Made a pair of them in about 20 min.

Hey I was wondering if you still had the drives? I'm in the Muncie area and would like to take a look at them. (765)748-8264

I still have 1 available

Only need one when you get a free minute give me a call