Gil bravo lenght dry tails fit merc center riser manifold
5 Attachment(s)
Have 4 Gil tailpipes to bolt right on to Merc center riser manifolds. Cheap way to get dry tails. 3' diameter. Some scratches. Could use a good polishing. Some minor surface discoloration towards the ends. One pipe pitted through the bottom next to the weep hole. $800.00 plus the ride.
|
ttt
|
ttt
|
What is the bolt pattern and dimensions of the base plate? I am looking to mod something for Chrysler manifolds.
|
Originally Posted by murfman
(Post 4489538)
What is the bolt pattern and dimensions of the base plate? I am looking to mod something for Chrysler manifolds.
|
3.5 inches center to center front to back and 3 inches across
|
Base plate is 4 1/2 by 4
|
bump
|
ttt
|
going up
|
PM Sent
|
checked inbox and did not see your pm
|
So these bolt on top of just a bone stock (center rise) factory exhaust manifold?? And go all the way out transom and are dry to the tip? (Assuming i would just need transom rings). Just wanna make sure im reading it all corectly. Havent seen aftermarket riser/tails for factory manifolds before. Any performance gains ya think? Or just sound/looks...?
|
Sold.............Heading to Florida.
|
All times are GMT -5. The time now is 06:02 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.