|
Any interest in a standard length Imco lower? Satin finish, 1.25 prop shaft, no twisted splines.. I'm interested in a 540 short block..
|
Originally Posted by Sick Stinger
(Post 4560165)
Crank
rods pistons blocks timing covers chains harmonics cams lifters lifter spiders heads are complete also have push rods also, 1 piece Manley? I believe |
Those are GM 502 blocks in photo, what was done to make 540.
|
Yup they are GM block in the picture because they are GM block motors in selling. Unless you can't stroke a GM block, and the only way I know to make a 540's is to get a stroker crank and rod set up. Unless there is another way?
|
One motor sold
have a set of Merlin steel heads also available |
| All times are GMT -5. The time now is 07:17 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.