Gil Exhaust Riser Wedges
These were created on a CAD machine to raise or lower the height of the exhaust pipe at the transom. They are placed between the manifold and the riser with a gasket on either side. They were cut from the mounting bases of old Gil risers and are 3/16" thick on one side and 7/16" thick on the other. The amount of vertical movement depends on the distance from the back of the wedge to the transom but is approximately 9/16" for every foot of travel. Very useful if your transom exhaust cut-out is misaligned with the end of the exhaust pipe pipe. I'll take $200.00 +$10.00 shipping for all 4, which is less than I paid to have them machined. I've also got 1 blue silicone 4" hump hose, never used: $15.00.https://cimg9.ibsrv.net/gimg/www.off...365cefdc33.jpg
https://cimg7.ibsrv.net/gimg/www.off...64c47081d9.jpg https://cimg8.ibsrv.net/gimg/www.off...f1df88dbb4.jpg |
So I take it these are SS ?
|
Yes, they're cut from old risers.
|
Do you still have these
|
Originally Posted by ctuck0659
(Post 4677547)
Yes, they're cut from old risers.
|
I still have the riser wedges. Pipe scraps are long gone.
|
Are these available still?
|
Still got 'em-
|
Bump
|
All times are GMT -5. The time now is 12:21 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.