1k for both carbs? What you up to now? Sounds all to familiar on this end. ****ttt never ends.

They’re designed to work with wet exhaust, and just happen to be effective with dry exhaust as well.

I’ll do 1k both plus the ride. Let’s just say zl1 superchargers, Johnson short travel lifters, ported heads, ported superchargers, ferrea super alloy Valve’s and stainless intakes, Manton 3/8 pushrods, and Holley efi. As well as some paint work and powder coat work on the boat.

27 mirage props and drive spacers sold

They will fit in the exhaust itself. Not the tips

https://cimg3.ibsrv.net/gimg/www.off...f0cde7913.jpeg
Here’s more info on the carbs

PM going out now for pymt/address info etc. Tks John. Always difficult in this pocket drawing hobby is when your finally satisfied. I honestly don't think ever unless you get out of it.

:flag:

PMed you back

Msd boxes sold

Right, I understand that, but the old GGB pages that I can still find list both a 3.5" and a 4". I suspect that the 3.5" is designed for a fully jacketed dry 4" exhaust that actually has a 3.5" inner pipe - is that correct? So if that is the case, as the seller stated, they probably aren't designed to fit in a standard 4" exhaust tip. It sounds like if they were bolted into a set of 4" tips, they would fit but they would be off center. :(