Trade IMCO SC Steering Caps
I have 2 IMCO SC steering caps that have two ears that both point to on side. They are setup to be run with twin rams and a connecting bar. They are black and in good condition. I'm looking to trade for set of AEC-7 steering caps that are setup for use in a single engine setup. Pictured below is what I'm looking for. PM me or text at 810-240-2580. Andrew
https://cimg3.ibsrv.net/gimg/www.off...905ced787.jpeg |
Can you post the pictures of the one you have because it sounds like I need yours and you need mine
mine have the mounting on each side it just does not have the center hole as in the pictures above |
Originally Posted by hullofjustis
(Post 4774203)
Can you post the pictures of the one you have because it sounds like I need yours and you need mine
mine have the mounting on each side it just does not have the center hole as in the pictures above https://cimg7.ibsrv.net/gimg/www.off...839eb6c91.jpeg https://cimg8.ibsrv.net/gimg/www.off...c3adc71f9.jpeg |
The bottom pic is different then the top pic. The ones I could use are the top ones. Which do you have?
|
Originally Posted by hullofjustis
(Post 4774371)
The bottom pic is different then the top pic. The ones I could use are the top ones. Which do you have?
|
I’ll take a pic of what I have tomorrow and post it
|
Originally Posted by hullofjustis
(Post 4774666)
I’ll take a pic of what I have tomorrow and post it
|
These are the imco back caps I have the pins/bolts however since I have Latham rams I had to have them machined to fit the smaller Clevis ,until I found the correct bushinged imco style clevis . The pic below is how I currently have it set up with the saddles which I do not want to use this way I’d prefer to have them all mounted to the imco caps .
https://cimg6.ibsrv.net/gimg/www.off...59594fc24a.png https://cimg1.ibsrv.net/gimg/www.off...2969de8ba.jpeg https://cimg2.ibsrv.net/gimg/www.off...5c764a7bf.jpeg |
Originally Posted by hullofjustis
(Post 4775017)
These are the imco back caps I have the pins/bolts however since I have Latham rams I had to have them machined to fit the smaller Clevis ,until I found the correct bushinged imco style clevis . The pic below is how I currently have it set up with the saddles which I do not want to use this way I’d prefer to have them all mounted to the imco caps .
|
Your pm box is full.
|
All times are GMT -5. The time now is 11:19 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.