helm
 

Looking for a 120cc-145cc hydraulic helm and the steering column etc. possibly even a steering wheel.

I have a Hydralic helm (although I will have to check & see what cc it is when I get to the shop tomorrow)

I also have a tilt column assy. that was used with that particular helm , with a nice extinsion & Dino wheel attached to it...

I will post a pic. here in just a few minutes

Here is a pic. of the column with tilt unit & the wheel... Like I said I will check on the helm tomorrow in the morning..

I'm also looking for a 120 cc open center helm , open center ( for use with a power steering pump ) if you pass on it let me know

Larry

I am trying to find out some info on the unit I have... It is a Char-Lynn (Eaton) Here are some of the #'s on it: M06030238 X291-1090-001

Here is a pic.

What are you wanting this for ?? Single ram , Twin ram , what size cylinders ect... I am not a hydraulic expert by no means & to be quite honest am a bit ignorant on them so I am open to learning a bit...

This particular unit was used on a twin setup with XR ITS's (which are smaller rams in size than most , however I am cluless as to the volume ect..)

Twin ram, 9 inch stroke, cant remember cyl diameter. anywhere between 120 and 145 cc will give me a decent lock to lock I think. I'll do a bit of research on yours. What are you looking to get out of it?

anyone else? still looking.

Will this work-

I really like that wheel. I need a hydraulic helm as well though. What do you want for the column and wheel?

$250,00 sound O.K.