500 Hp block and heads
 

looking for just a stock bore block and heads
I am looking to build a motor identical to motors I have in my Cig Bullet to go into my Cig 20
The base for those motors were a 500hps .030 over with ported heads and all new internals and would like to do the same so just need block heads and crank

I have a set of fresh steel heads for a Gen IV - (2) sets, new springs retainers etc..... I think one set has not been run and the other set 5 hrs ???- Price is right and they need to find a good home - you pay for shipping

thanks looking for a Gen 5

hp500
 

I have a complete hp 500 that burned the cylinder wall extra parts head rods new take out pistions.
p.m. me
thumper038

Klaw,

I may have miswrote, these heads are off a 1996 HP500 they may be gen V, I'll have a look tonight

ye sif the are a 1996 they should be gen 5 I think

Klaw, I have a set of fresh water cooled Gen 5 gm cyl
heads 502 that need to be cleaned . slight rust due to sitting for years . need to be boiled ..They had less than 10 hrs when pulled of the block. They were of a 502 crusader motor . $ 300 for both. Tom

picture