looking for a tie bar saddle
 

Looking for a bravo 1 tie bar saddle for a rod end bar, 5/8" thread

I have a set of IMCO ends. 3/4 afterthought

email me at [email protected] with pics if you have them, price, and width at connection point (are they sized for spacers or not)

THANKS!

YZ

Fit tight against the bravo housing. No spacers. They are for 3/4 rod ends though. Not sure what they are worth. Make an offer. (don't want to ask too muich)

pretty sure i have a new Latham at home thats 5/8's. I'll check this evening.

The one I have is Latham so that would work easier than buying two, Charliem: can you please measure the opening where it attaches to the drive unit (I can't open your pic) Thanks all!

YZ

I didn't forget you. Got called back into work. I'll post a pic tomorrow

Latham tie bar saddle
 

Here's a few pics of the one I have. Thinest part of the top stem measures 3/4" though. I know you said 5/8" but are you sure? That's really thin. I thought this one was 5/8" until I measured it. If it will work for you say $60. shipped. It's never been under water.

I'm sure it's 5/8 for the threaded part - a pretty common size for the bravo ones -- I can't open the pics, can you please email them to me at [email protected]

Thanks!

Sent to your email