HP500 Parts
 

I bought an HP500 carbureted motor that was supposed to be drop in ready but its missing a few things :-(

Any help would be great.

Oil cooler w/ thermostat set-up
Alternator / power steering pump bracket
Water pump pulley
Cooling temp sending unit (alarm / sender)

I have a used alternator/ps bump bracket with the two braces from a Mk IV 502pt #806394A1 (I think). $125.00 shipped USPS from Ontario.
Phil

i have the water pump pulley off a 500

That Oil cooler in the swap shop is what you need and a good deal... the thermostat is not in the oil cooler, its in the oil filter housing assembly that is bolted to the back of the engine.

I have the oli cooler the thermo housing and lines. All listed in swap shop

if you are swapping it with your existng 502 why dont you use the serpentine setup off of it? run it with a electric fuel pump also since the sea pump wont have provisions for the mechanical fuel pump.

The measurements are not the same. Its not as easy as it seems to convert a triple v belt to serp. All the accessories are at different offsets so that all the belts can meet.

if he takes all of the exiting accessories off the 502 they will all bolt right onto the hp500. exteranally those motors are pretty much identical. there is no reason it would not work. no issues with offsets at all

have 2 warer pump pulleys, 2 thermostat housings, 2 1" spacers for under your carbs, private message me if any intrest.

Still looking for a power steering cooler (and bracket if you have it) for an hp 500......