Looking for #4 spacers
 

what ya got?

spacer's
 

I have a pair of 2 inch if that helps you.

How much Sir??

500.00 plus shipping

Sounds fair, what about the studs and coupler, included?

thanx

Dan

The #4's don't use a spacer it has a polygon shaft .The studs would be extra if I have them.

Hey bud, not too familiar with the SSM IV spacers, but he needs pretty much everything to install onto a set of standard #4 drives. Thanks

Frank you mean they don`t use a coupler?

I will see if I have the studs and let you guys know,asap

correct they don't use a coupler.

This forums quote machine is broken lol

Spacers
 

I have a pair of 1" spacers that came off #5's if they will work.

Not sure if those will work on a iv with the polygon shafts. Ill have to ask around about that. Never messed with the spacer stuff on these drives

The #5 spacer's will work the difference is the tilt pin hole on the #4 is 7/8 and the #5 is 1" you can use a bushing or get a 1" tilt pin.I have the 2" spacer if you guy's need them.I don't have the studs for the 2" spacer at this time but I can get them if you need them,they are expensive from mercury.

trim pins
 

You can use a section of 1" od stainless tubing, approx. 1/4" shorter than the length of the hole in the #5 2" spacer, to make up the difference between the #4 7/8" pin and the 1" hole that is in a #5 spacer. Also if you want longer studs for either a 1" or a 2" or a 3" spacer you can buy longer ss bolts, cut off the hex. end and thread either fine or course threads to make new longer "studs" for a lot less than Mercury wants for their studs. I know that both of the above work as I have done both.
Call me if you want more help.
Gary
612-247-7081

Can you guys point me in the right direction for the studs from Mercury?