trim sender covers
 

Converting to mechanical indicators and id like to remove the trim senders while the transom assembly is off the boat does anyone have covers or know where i can get some? Ive seen some custom made by Smokin gun but i haven't had any luck searching for them
thanks
bobby

I think you want #10. HP assemblies had a no sender option and I think this was the cover.

http://www.mercruiserparts.com/bam/s...31000/11406/90

Is what you are looking for is a cover to put over the stock pivoit pin we make a S/S plate that screws into the stock holes its make of 7 ga stainless

yup I was making them at 1 time ,out of 316 L stainless polished with stainless allen heads $70 a pair shipped couldent sell em made about 40 .gave up I couldent sell em for less than it cost

Yeah rather then converting it to the hp transom assembly I was trying to just throw some covers on it for now eventually I'll swap them out ...I should have done it when I rebuilt it but I wasn't planning on using mechanical indicators ...I know the electric senders aren't sealed so I don't see it being an issue leaving them open for now but with all the fresh stuff on the transom it looks bad that's all

Yes just a cover for the hinge pin