Gen 6 502 motor
 

My motor spun a couple rod bearing and now the machine shop told me the crank is bad. So now im debating on buying a new cranks, rods, bearing, etc to rebuild my motor or buying a new one. New ones are pretty exspensive and then the core charges and shipping makes it a bit out of reach. Thought i would see what someone here may have before i make my decision. I have a blower that goes on it so long blocks or best but can remove intakes if its a complete motor. Also i out of washington state. Seattle area

thanks

the one I have I can rebuild was just thinking for the money I'm going to spend on rebuilding someone may have one done for not much more. thanks though..