K-Plane drill template
 

Hey, looking for a k plane drilling template, hopefully someone as one they are willing to part with.

Thanks!

Wally in the board has a template for them. He send me a few.

On’ sorry not in.

any chance you have his user name so i can send a dm? Thanks!

It’s Wally

I just made my own from heavy paper then to a 1/4" paneling template and a tee square. Both sides drilled and ready for install in apprx 1 hour including templates. Was a bad day though on this particular install. Port side went as expected. Stbd side once the drill bit went through the layer of glass it was like your clutch slipping badly before you make it to the toilet. Lol. Looked like it also.

Templates woulda been nice but wasn't necessary. Just think it through and start with a smaller bit. If I recall I only had one hole I needed to open up slightly on the inner transom. No biggy. T square and good eyes are key.

Hey, i replied to your PM as well...
I do have a template i drew up on AutoCad a while back....i based it off of my old k-planes. I can either email you a pdf of it that you would need to print full size or send you a couple prints through the mail...let me know :cool:

Wally I just noticed your signature for the first time. How true and hilarious!

What you may be looking for is Kiekhaefer / Quicksilver Drawing # 90-843570 . I have one you can use. PM me and we can work it out.