SSM 19 spline props
 

Looking for a left and right 16 3/4 x 24
or 16 1/2 x 25.

Thanks,

3 blade or 4 blade? I might have both in 3 blade, but their short hub I believe.

Think I have 3 blades close or at that.

3 or 4 blade. Prop shafts are approx 3 1/2” below. Seems like I recall Valako saying 4 blade be better option but not sure. I’ll measure the hubs. Tks john

There for a 12m ftn

I'll check tonight when I go down to the shop. I might have 3 sets of 3 blades I think, and maybe, just maybe a set of 4 blade 24s or 25s (4 blades would be long shaft) I'll let ya know.

I have a set of 16x25 3 blades of your interested.

6” hubs. Thank you!

Still need. Tks.

Would you interested in running a 4.5 hub with a spacer? (That's how I ran them)

I have the spacers too.i think.

I have short hub sets of 25 and 26 3 blade. Might have a set of 24 3-blade if my memory serves me. (in a box on the high shelves, so I didn't look unless you're interested) I think my bronze spacers were "borrowed" and never made it back home. Easy to fab. Let me know! All are 16.5 or there abouts.

So I can just have some spacers machined and use the short hub? If so then for sure if you can confirm what all you have would be great. I want to turn 6k min so the 24’s or 25’s would likely work or be closer than my 16 3/4 X 27’s.

Tks very much and and look forward to your response!

john

I have a set of 16 1/8 x 23 4 blades long hub if interested Regards Dan 949-646-9778

will text today.
tks

Ttt

I have a set of props from a speedmasster 2 that are 3 blade, 15x24. Right and left hand with the shaft spacers, I also have the lower units if you need any parts