Extension box (Neutral) for Bravo 1 setup
 

Looking for Neutral IMCO extension box kit or equal to install on my Chris Craft 8M. (equipped with singel HP500 and Bravo 1 outdrive)
Open for one ot two kits.
Also looking for external hydraulic steeriing for this setup.

Best regards
Lars

I am unfortunately not able to read or answer on PM as I do not have enough posts. I will read received PMs as son as I get the access. ;)

I have. Imco box. And Steering. Send me your number I will send you pics over

Getting a box in next week.
with an XR and 380s

I have two stellings boxes that can be run anywhere from neutral to raised 2” and all of the Latham steering for them. They include 4 extra used gaskets as well. Here are pictures, let me find the price list from Latham on what the steering parts cost.
https://cimg6.ibsrv.net/gimg/www.off...6a0779ecb.jpeg
https://cimg9.ibsrv.net/gimg/www.off...1a4e1ac7a.jpeg
https://cimg3.ibsrv.net/gimg/www.off...ad6ca8e2d.jpeg
https://cimg6.ibsrv.net/gimg/www.off...f45ebe331.jpeg
https://cimg8.ibsrv.net/gimg/www.off...1cac738df.jpeg
https://cimg0.ibsrv.net/gimg/www.off...aa24b9fc1.jpeg
https://cimg1.ibsrv.net/gimg/www.off...7a639c8bf.jpeg
https://cimg2.ibsrv.net/gimg/www.off...3527d9107.jpeg
https://cimg5.ibsrv.net/gimg/www.off...2bb25763d.jpeg

This is from my original for sale Ad in the swap shop on here a couple months ago, asking 8k now. Tie bar is also Latham. Not using them and just taking up shelf space now.

Hard one to set a price on, I have seen several of the extension boxes up for sale over the last couple years for 6k a pair so started with that. Asking $10,500 for everything, open to offers.



Per Latham, the steering price breakdown is as follows-

Rams with medium clevis would be $2,200 each

Back caps are $728 each.

Top caps are $761 each.

Bolt kit for the top caps for the ram $127 each.

Steering would cost over $7,600.

Transom assemblies are not included.



Brand new Teague drive showers included. You will need to thread the big hole in the top cap for the elbow to thread into them.



The mounting holes for the boxes have been milled at some point so instead of the holes being neutral, up one inch and up two inch there are slots so it can be set wherever. I have aluminum stock that has been routed and cut to either set them at neutral or 2”.



I will be including the tie bar that came off the boat. I will get more information on that this weekend such as length and brand.



Also included are 4 extra (used) seals for the access plates.



I will ship on a pallet or local pickup in 43066.

Thanks, I may have found two sets close to home. I will check them first befor I come back.