The lift is in - finally
 

A quick note of thanks everyone at Moores who helped me get Donnie's old lift loaded on the flatbed last month. Finally made the time to set the bunks up correctly for the step in the hull this Sunday after the run. Works great.

RP

Post a pic of the bunks please. I want to see what i should be doing for my step hull.

glad to hear it worked out for you
it was nice meeting you and your wife and maybe we can run down there next year by water and catch up with you

thanks again

Nice meeting you as well, might end up down that way in August.

I have the same lift.. you can put valves between the tanks to level it out if needed.. thats what i did..

lift makes life much better!

I'll upload a few pics for you this weekend - doing the road show this week.

Thanks - this one had a valve between the center tank and the rear tank, but I may add one between the forward tanks and the center as well. I am also thinking of putting Tees with a valve right before the blowers so that I can lower the lift without having to worry about moisture and water getting into the blowers. Tanks will also lower faster. Had this set up built into my old Hydro hoist and it worked much better.

Hope to catch up with all of you again sometime in the hopefully no to distant future.

Pics for Elite
 

Here are the pics. My bunk support brackets were all the same length, but I got lucky because my step is right at 1.5". I stacked two 2x6 boards on the back bunk to make the step bunks and used a single board for the forward bunk.

Hope this helps.

Regards

RP

Thanks!